If you choose to add a finishing service (anodizing, plating, or powder coating) to parts, we will apply the finish to the entire part. We’re unable to finish specific areas or portions of parts, and not other areas. We cannot provide masking for areas of your part.
Please note; bending, countersinking, dimple forming, and tapping services are performed before finishing services.
Hardware is installed after anodizing and plating, but before powder coating.
Parts with both hardware and powder coating services will have the hardware capped/plugged before being powder coated.
Check out the individual guidelines for each service so you’ll know what to expect when you receive your parts!




Powder coating + PEM flush studs and flush standoffs

Red anodizing, clear anodizing, and yellow zinc plating + PEM hardware


Finishing + dimple forming