Our nickel plating is quite thin (adding approximately ~0.0002″ per side), so you will need to be careful to avoid wearing through the finish. A small amount of light polishing may be doable but any more aggressive treatment like sanding could penetrate through to the underlying material.
This June, Spend $1,000 or more at checkout, you’ll receive 5% off instantly + a $200 gift card towards a future purchase.
"*" indicates required fields
We proudly use hardware by PEM
| SKU | SO-440-8 |
| Thread Size | 4-40 x .250″ |
| Hole size in sheet (+0.003/-.0.000) | .168″ |
| Minimum sheet thickness | 0.040″ |
| Maximum sheet thickness | .125″ |
| Fastener material | Steel |
| Minimum distance hole C/L to edge | 0.230″ |
| When determining the distance between two or more fasteners, you can calculate the distance by the formula, C/L to edge + 1/2 the diameter of the second mounting hole. | .314″ |
| Recommended panel material | Steel/Aluminum |
| Coating type | Zinc |
| Length | .250″ |
| Aluminum material ranges (5052, 6061, 7075) | 0.040″-0.125″ |
| Steel material ranges (CRS, HRPO, HR) | 0.048″-0.119″ |
