Do you offer tumbling?

At SendCutSend, we do offer tumbling services! We soften the edges of laser cut parts and remove burrs on small parts through a ceramic tumbling process. We use specialized equipment harmonically tuned to the specific material. This allows us to achieve a more consistent finish across the parts. Take a look at our guidelines here: Tumbling Design Guidelines

Please note, this is not a finishing process and does not guarantee a uniform finish on the individual parts. However it will prepare your parts for later surface finishes or chemical brightening.

If you need finishing services, we can help! Check out our anodizing, plating, and powder coating services to see if there’s a good fit for your project.

Examples of tumbled brass, aluminum, and copper parts.
Tumbled brass, aluminum, and copper parts.

Start your first SendCutSend project today!

Upload your CAD design or use our parts builder and get instant pricing on your custom laser cut parts, all delivered to your door in a matter of days.

We proudly use hardware by PEM

Flush Standoff, 4-40, .250" Zinc plus Clear Chromate

Aluminum: 5052, 6061, 7075 Steel: Mild, G30

SKUSO-440-8
Thread Size4-40 x .250″
Hole size in sheet (+0.003/-.0.000).168″
Minimum sheet thickness0.040″
Maximum sheet thickness.125″
Fastener materialSteel
Minimum distance hole C/L to edge0.230″
When determining the distance between two or more fasteners, you can calculate the distance by the formula, C/L to edge + 1/2 the diameter of the second mounting hole..345″
Recommended panel materialSteel/Aluminum
Coating typeZinc
Length.250″
Aluminum material ranges (5052, 6061, 7075)0.040″-0.125″
Steel material ranges (CRS, HRPO, HR)0.048″-0.119″

We proudly use hardware by PEM

Flush Standoff, 4-40, .250" Passivated

Stainless Steel: 304, 316

SKUSO4-440-8
Thread Size440
Hole size in sheet (+0.003/-.0.000).166″
Minimum sheet thickness0.04″
Maximum sheet thickness.125″
Fastener material400 Stainless Steel
Minimum distance hole C/L to edge0.230″
When determining the distance between two or more fasteners, you can calculate the distance by the formula, C/L to edge + 1/2 the diameter of the second mounting hole. Example shown with x2 of the same hardware..313″
Recommended panel materialStainless Steel
Coating typePassivated
Length.250″
304 Stainless Steel material ranges0.048″-0.125″
316 Stainless Steel material ranges0.060″-0.125″